View single post by Budget Appliance Repair
 Posted: Wed Apr 18th, 2007 06:53 am
PM Quote Reply Full Topic
Budget Appliance Repair

 

Joined: Sat Apr 2nd, 2005
Location: Eureka, California USA
Posts: 2364
Status: 
Offline
 Actually, you don't have to remove the pulley to change the snubber ring. Also leaving the pulley on will prevent you from accidentally letting the stator plate fly off into your face if you take the screws out too far, you won't need the longer screws, just back the existing ones out just a little at a time even all the way around until you can get the old snubber out. You may have to unscrew each just a little more to give enough room to wedge the new one back into place.

The corn starch goes on the base plate were the snubber rides, not between the bottom of the milk stool and snubber ring.

You should clean the bottom of the milk stool area were the snubber goes with an alcohol coated rag, careful of sliding the fingers under or around that stator plate though, it can very easily slice your finger quite badly, appliance metal edges are very sharp!!!!!



____________________
William Burk (Willie)
Willie's Budget Appliance Repair
Eureka, CA 95501