 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Mon Apr 16th, 2007 |
| Location: | London, Ontario Canada |
| Posts: | 5 |
| Status: |
Offline
|
I still have a few questions that seemed to be unanswered in this thread. I am trying to make sure I will not run into problems after I start as I can't have the machine down too long or I will be in trouble from guess who, so I am asking all the questions now trying to cover all bases before I get into this.
1. It looks like once the 6 springs are removed, the tub and milk stool assembly will just lift off the base. Is this correct?
2. The article doesn't mention taking off the pully. I assume this must be done as the snubber ring won't fit over it.. Correct?? If so, there is a plastic cap on the bottom of the shaft. Does this just pull off?? Any other tips to taking off the pully?? I haven't looked closley at this yet so I am asking these questions to get tips just in case there are unforseen problems.
3. Now, once I loosen the 6 screws and get the old ring out, do I just slide my finger with an alchol soaked cloth in there and blindly wipe around it?? I assume that there won't be much room to get in there. Then do I just try and get some corn starch in there and also wipe it on the snubber ring before placing it in there?
4. I assume the ring (I haven't got it yet) can be just squeezed enough to slide it out and the new one in??
Thanks in advance for any answers to these questions
DavieWhite(new apprentice appliantologist)
Last edited on Tue Apr 17th, 2007 02:06 pm by Daviewhite