View single post by dlinscott
 Posted: Sat Oct 14th, 2006 10:00 pm
PM Quote Reply Full Topic
dlinscott

 

Joined: Sat Oct 14th, 2006
Location:  
Posts: 2
Status: 
Offline
Willie,

I have the same problem with a GE GSD4030Z02WW leaking from the drain shaft when the solenoid is activated.  I was wondering whether the shaft pulled out of the pump assembly and I see that is not the way to do it.  But - the plastic piece the soleniod pulls down and the shaft goes through does not seem like I can pull it off the shaft.  The end of the shaft has been rolled (not sure if that is the correct term) so it is larger than the hole it goes through in the plastic.  Does this mean I would have to pull the whole thing apart and pull the shaft out of the valve?

Thanks,

David