 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Wed Apr 6th, 2005 |
| Location: | St. Charles, Illinois USA |
| Posts: | 25 |
| Status: |
Offline
|
I would concur with your observation. But the cam does show some deformation and wear if compared with the good one ashown by Samurai.
I believe the difference is they are two different part designs. Perhaps there are two different clutches, one larger in diameter than the other. The part I have is not worn down in any sigficant way.
After looking at some exploded diagrams and from the way the trans feels I'm guessing I'm missing a few teeth from the spin gear. The roughness doesn't happen often enough to be the pinion and the amount of roughness would mean a large part of the pinion would be gone.
I can't tell but it might be this large plastic gear in this picture.
Steve
Last edited on Thu Apr 7th, 2005 06:55 pm by steve