View single post by Budget Appliance Repair
 Posted: Sat May 21st, 2005 02:21 pm
PM Quote Reply Full Topic
Budget Appliance Repair

 

Joined: Sat Apr 2nd, 2005
Location: Eureka, California USA
Posts: 2870
Status: 
Offline
Grab hold of the spin basket by the edge and give it a good push down and back up, it should come loose with just a couple bounces.

Also, you don't need to remove the tub to see if the drive block is bad. Look at the picture posted above and if yours looks like the picture then the drive block isn't your problem. Notice the two tabs that are level with the top of the drive block, that is what your looking for. If your drive block is bad the spin tube, which has the two tabs sticking up , will be sticking about a 1/2" to 1" above the top of the drive block.

Last edited on Sat May 21st, 2005 02:24 pm by Budget Appliance Repair



____________________
William Burk (Willie)
Willie's Budget Appliance Repair
Eureka, CA 95501