View single post by Gmaxx
 Posted: Wed Mar 8th, 2006 09:54 pm
PM Quote Reply Full Topic
Gmaxx



Joined: Fri Mar 3rd, 2006
Location: Ohio USA
Posts: 166
Status: 
Offline
 Checking the selector switch contacts responsible for the Bake would be a good place to start.

First cut the power to the range.

Set your meter for the ohms/resistance setting.

Go to the upper oven selector switch and run continuity checks between the following terminals

listed below with the switch in the Off position and give us the results. Does the meter change and give you a reading? Or do you get nothing? In this case nothing is good. If you get a reading double check it by pulling one of the wires off of the switch terminals you’re working with then check the switch terminal again. This will insure that you’re not getting a false reading generated by the other components connected to it.

 

Between terminals

A to M

K to D

P to B