View single post by Tarheel Technician
 Posted: Mon Jun 29th, 2009 08:04 pm
PM Quote Reply Full Topic
Tarheel Technician

 

Joined: Fri Apr 8th, 2005
Location: North Carolina USA
Posts: 114
Status: 
Offline
 After some research, looks like with an analog meter, the leads are supposed to be reversed. I did not know that. So........... that puts me with this situation:

Control board is receiving 110 volts........and all the buttons on the user interface are checking good with my meter. However, the unit does nothing...no lights.....nothing.

As I stated in an earlier post....I have already tried a new control board and it still doesn't work..........so I assume (and u know what they say about assume) it needs a user interface. Just hesitant to order that when it seems to be ok when doing the test on the ribbon connectors.

But by looking at the wiring diagram, I don't see anything else that it could be!

Sometimes I hate electronics! Of course, on some occasions when the error codes point you right to the problem, I love them!