 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Sat Sep 24th, 2005 |
| Location: | Milwaukee, Wisconsin USA |
| Posts: | 9060 |
| Status: |
Offline
|
... I checked the voltage across pins 2 & 6 on the power harness for the motor, and I measured 89 V...Was that voltage measurement with the Motor connected ?
(all voltage measurements should be with the device connected, unless otherwise specified)
It should have ran or hummed ..
You could try swaping the (2) Relays
You measured the 240v supply... did you also check for the 120v ? (Neutral)
Last edited on Sun Jun 28th, 2009 11:21 pm by RegUS_PatOff
____________________
RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw
my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA
Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?"