 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Mon Mar 21st, 2005 |
| Location: | Otterville, USA |
| Posts: | 12947 |
| Status: |
Offline
|
Will need your ezzact model number to get into 'pacifics.
____________________
Links: Parts | FAQs | Store | Beer | Home
| View single post by Samurai Appliance Repair Man | |||||||||||||
| Posted: Tue Jun 23rd, 2009 01:28 pm |
|
||||||||||||
Samurai Appliance Repair Man
|
This is *usually* a problem with the heating circuit. Suspects include a burnt relay solder joint on the control board, open heater, open heater temp sensor. Can also measure current draw a few minutes after starting a cycle-- if the heater's working, you'll be drawing about 11 amps, otherwise, about 1.2 amps. Will need your ezzact model number to get into 'pacifics.
____________________ Links: Parts | FAQs | Store | Beer | Home |
||||||||||||
|
| |||||||||||||