View single post by wandering_burr
 Posted: Mon Jul 14th, 2008 09:57 pm
PM Quote Reply Full Topic
wandering_burr

 

Joined: Mon Jul 14th, 2008
Location:  
Posts: 13
Status: 
Offline
 I followed the directions but when i remove the control lever there is no seal or nut in evidence. Just the shaft coming out of the housing. I looked around under the machine looking for evidence it rotted and fell off but could not find anything. The machine is a GE GSD4330Z02WW.

I looked at the posted diagram for this model and it appears that the push nut and seal should be there. Not sure if i'm missing a step that others didn't need explained to them?

I bought the seal locally but no-one here has a push nut in stock. I tried just the seal but that didn't work-still leaks. I now have the push nut on a rush order. Is it safe to assume these instructions are still valid or was there some variant of sealing the shaft that my machine may have?

Thanks.