|
FAQs | Parts | Service | Store | Newsletter | Sitemap | Beer | Fixitnow.com |
ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher Paykel DD603 Service Manual |
|
FAQs | Parts | Service | Store | Newsletter | Sitemap | Beer | Fixitnow.com |
ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher Paykel DD603 Service Manual |
Konnichiwa and Welcome!Please register to post a question. It's FREE!
|
| Moderated by: RegUS_PatOff, Pegi, appl.tech.29501 |
|
Page:   1 2 3 4 5 6 7   |
|
||||||||||||
| Fisher Paykel DD603 Service Manual | Rate Topic |
| Author | Post |
|---|
| Posted: Sun Jan 18th, 2009 03:45 am |
|
101st Post |
|
Phreddy Senior Apprentice Appliantologist
|
Dear Master, I'm having a problem with a wrench getting thrown at me in the last rinse cycle of a DS603 (same brains as a DD603 I imagine). Could I get a copy of the service manual? Thanks a million brewski's... Last edited on Sun Jan 18th, 2009 02:41 pm by Phreddy |
||||||||||||||
| |||||||||||||||
| Posted: Sun Jan 18th, 2009 04:02 am |
|
102nd Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology 
|
Phreddy wrote: Dear Master,manuals sent you coudl now delete your emaila address ... Last edited on Sun Jan 18th, 2009 04:02 am by RegUS_PatOff ____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Fri Feb 6th, 2009 07:38 am |
|
103rd Post |
|
Alistair Senior Apprentice Appliantologist
|
I also am in need of the DD603 manuals (I am in Australia if that matters). E-mail address is I had a few little ants crawl over the controller (525) for the top draw. This blew the big capacitor, one of the transistors is fried, etc (and the ants were cooked). All in all the controller is well and truly dead. So I ordered a new one through F&P Australia. This was easy and it turned up on time. When I put it in the draw was still dead, no power etc. The new one works in the bottom draw no worries, neither of the good ones work in the top (I should have checked the bottom one in the top ...) Any advice would be much appreciated. If I get the manuals and work it out I will post my solution. Last edited on Fri Feb 6th, 2009 08:23 am by Alistair |
||||||||||||||
| |||||||||||||||
| Posted: Fri Feb 6th, 2009 07:59 am |
|
104th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
Alistair wrote: I also am in need of the DD603 manuals (I am in Australia if that matters). E-mail address is aln.... @...alistair....comOK, turn them right-side up when you get them ...  manuals sent
____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Fri Feb 6th, 2009 08:23 am |
|
105th Post |
|
Alistair Senior Apprentice Appliantologist
|
so quick - thanks
|
||||||||||||||
| |||||||||||||||
| Posted: Sat Feb 7th, 2009 10:38 pm |
|
106th Post |
|
Alistair Senior Apprentice Appliantologist
|
Thanks to your help the dishwasher is fixed. The problem was the power supply to the controller. Power to the controller depends on the heating element. This element has a short length of solder (about 15 mm) that acts as a thermal fuse. It is soldered to the heating element tracks. Mine had blown (melted). There was a dob of melted solder just below the element. I guess I could have replaced the heating element. However, I could not be bothered waiting for it to turn up so I decided to try putting another bit of solder on. I used 60/40 tin/lead 0.8mm resin core solder. It was a bitch getting it to stick to the heating element track. Eventually I kind of succeeded by melting out the resin, then applying a dob of melted solder to each side, followed by attaching a join to each side. After I put it all back together it did not work first time, but at least I had power to the controller. I put the controller into diagnostic mode. After I exited everything sort of worked. I suspect that my solder join on the heating element is a bit flaky and I am not quite getting the right voltage to the controller. Going into the temp/voltage display mode (start a cycle, keylock for 4 seconds, then start/pause for 8 seconds) I get a voltage of around 60, but it fluctuates quite a bit. Any idea what it is meant to be?
|
|||||||||||||
| ||||||||||||||
| Posted: Wed Feb 11th, 2009 08:03 pm |
|
107th Post |
|
dnonnema Senior Apprentice Appliantologist
|
hi there, would you please send a service manual for the DD603 FP? Thanks! Last edited on Wed Feb 11th, 2009 10:00 pm by dnonnema |
||||||||||||||
| |||||||||||||||
| Posted: Wed Feb 11th, 2009 09:34 pm |
|
108th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
dnonnema wrote: hi there, would you please send a service manual for the DD603 FP? Thanks! manuals sent
____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Sat Feb 14th, 2009 12:25 am |
|
109th Post |
|
ericoppel Senior Apprentice Appliantologist
|
Hi, I noticed you seem to have a few Fisher and Paykel dishwasher manuals there. Any chance you might have one for the very common old FP913T that you could email to me please? Thanks, Eric.
|
||||||||||||||
| |||||||||||||||
| Posted: Sat Feb 14th, 2009 03:36 am |
|
110th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
sorry, searched... don't have anything for FP913T ohh.. 913T all I have is the parts manual Last edited on Sat Feb 14th, 2009 03:41 am by RegUS_PatOff ____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Sat Feb 14th, 2009 04:03 am |
|
111th Post |
|
ericoppel Senior Apprentice Appliantologist
|
 That's a great start. Much better than what I've got now!If you could email it that would be fantastic!! My email is ericoppelAToptushome.com.au Any idea whether it's necessary to use a silicon sealant when replacing the door seal on these things? I have another post asking about it but have no replies as yet. F&P used some around the top of the seal but I don't know what type to use? This is the first time I've attempted a dishwasher repair so I'm a bit lost and want to get it going again ASAP. I hate doing dishes!!!! 
|
||||||||||||||
| |||||||||||||||
| Posted: Sat Feb 14th, 2009 04:43 am |
|
112th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
parts manual sent Last edited on Sat Feb 14th, 2009 04:50 am by RegUS_PatOff ____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Fri Feb 20th, 2009 01:29 pm |
|
113th Post |
|
Budget Appliance Repair Fellow, Academy of Sublime Masters of Appliantology
|
Hi Reg, I see you're online, I sent you a PM for this manual. Just posting here also in hopes you see it soon. Thanks, Edit: I found a link to the manual in another discussion so you don't need to send it to me. Thanks Here's the discussion with the link to the manual: http://applianceguru.com/forum1/12241.html And a direct link if anyone else wants it: http://www.mediafire.com/?7eonemsxyyd Last edited on Fri Feb 20th, 2009 01:39 pm by Budget Appliance Repair ____________________ William Burk (Willie) Willie's Budget Appliance Repair Eureka, CA 95501 |
||||||||||||||
| |||||||||||||||
| Posted: Fri Feb 20th, 2009 02:34 pm |
|
114th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
Budget Appliance Repair wrote: Hi Reg, I see you're online, I sent you a PM for this manual.... besides the Service Manual, I also have the DD603 / DS603 Parts Manual and the Diagnostic Manual Last edited on Fri Feb 20th, 2009 02:35 pm by RegUS_PatOff ____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Sat Feb 21st, 2009 10:34 am |
|
115th Post |
|
Budget Appliance Repair Fellow, Academy of Sublime Masters of Appliantology
|
RegUS_PatOff wrote: Budget Appliance Repair wrote:Hi Reg, I see you're online, I sent you a PM for this manual.... Could you go ahead and email the parts and diagnostic manuals. Thanks,
____________________ William Burk (Willie) Willie's Budget Appliance Repair Eureka, CA 95501 |
||||||||||||||
| |||||||||||||||
| Posted: Sat Feb 21st, 2009 12:04 pm |
|
116th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
Budget Appliance Repair wrote: RegUS_PatOff wrote:Budget Appliance Repair wrote:Hi Reg, I see you're online, I sent you a PM for this manual.... manuals sent also note: links to Kitchenaid ( F&P ? ) Drawer Dishwashers: KitchenAid Dishwasher Drawer 50 MB 2008 Drawer Dishwasher 18 MB Last edited on Sat Feb 21st, 2009 12:14 pm by RegUS_PatOff ____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Posted: Sat Feb 21st, 2009 12:43 pm |
|
117th Post |
|
Budget Appliance Repair Fellow, Academy of Sublime Masters of Appliantology
|
Thanks, RegUS received manuals
____________________ William Burk (Willie) Willie's Budget Appliance Repair Eureka, CA 95501 |
||||||||||||||
| |||||||||||||||
| Posted: Thu Apr 2nd, 2009 12:17 am |
|
118th Post |
|
diywantabe Grasshopper
|
I started a new thread about my dd603 problem today but thought I'd request the manuals for it from here also. Thx
|
|||||||||||||
| ||||||||||||||
| Posted: Sun Oct 4th, 2009 08:50 pm |
|
119th Post |
|
docaluci Senior Apprentice Appliantologist
|
Hi Bugs. Love the cartoon. Could you send me the manuals also. I have an upper drawer that seems to be running on half power. like labors to close and motors all sound like they are working at half speed. Thank you. Email to dtbeech@wildblue.net. Greatly appreciated.
|
||||||||||||||
| |||||||||||||||
| Posted: Sun Oct 4th, 2009 10:40 pm |
|
120th Post |
|
RegUS_PatOff Fellow, Academy of Sublime Masters of Appliantology
|
links PM'd
____________________ RegUS_PatOff http://www.youtube.com/watch?v=oPAY2LsKVEw my video production: “Easter Seals Walk With Me” (also in HQ) http://www.youtube.com/watch?v=-EBiLyYXMiA Upon leaving this Earth "Do you want the Smoking or Non-Smoking section ?" |
|||||||||||||
| ||||||||||||||
| Current time is 03:23 pm | Page: 1 2 3 4 5 6 7 |
| ApplianceGuru.com: The Samurai Appliance Repair Forums > Do-It-Yourself Appliance Repair Help > The Kitchen Appliance Repair Forum > Fisher Paykel DD603 Service Manual | Top |
FAQs | Parts | Service | Store | Newsletter | Sitemap | Beer | Fixitnow.com
